Our KQET transmitter is now running at 85% power, which will be upgraded shortly. Most Over the Air viewers should be receiving the signal at this point, since many receivers would have automatically restored it once it returned to a near-normal level.
If you do not have a signal at this point, manually delete channel 25 from your receiver’s memory, then manually add channel 25 back in. If you cannot manually delete/add single channels in your system, then refer to the owner’s manual for your digital TV (or for the converter box hooked into your analog TV) for information about how to do a simple rescan for your system.
Some models don’t like to learn any new information, even when asked to do so during a simple rescan. If asking your TV/box to manually re-acquire the signal or simple rescans don’t seem to improve the situation, you can try a forced double rescan, which clears the memory, making your tuner as dumb as it was the first day you unboxed it, then ingests all new info.
1. unhook the antenna from the digital TV or converter box.
2. do the first rescan. the TV/box should report it found 0 channels
3. unplug the TV/box from the wall for 60-90 minutes, to be sure the box forgets everything it previously knew. some models have short-term back-up memory for power failures, so need more time to forget.
4. hook the antenna back into the TV/box, then plug the TV/box back into the wall.
5. if the TV/box doesn’t start rescanning on its own, tell it to rescan for the 2nd time.
The KQET transmitter on Fremont Peak is running at very low power levels. This is a temporary situation until the necessary parts are delivered.
Thank you for your support and patience.
Comcast will be doing work on Friday morning 12/20/13 (1:00AM-5:00AM) that will affect some local broadcasters. KQED channels will go off for approximately two minutes at some point during this window.
KQET at Fremont Peak is off the air till further notice. A PG&E outage caused damage to the controller in the transmitter.